I soldered my circuit together and attached a middle panel
between my front and back pieces. This was to hold the speakers in as, during
making, I realised that with the speaker grids slotted in the front panel,
there was no space for the speakers to go! I created this middle piece the
exact same size as the front panel by taking my original sketch from Crio and
inputting it in to Corel Draw, in order to laser cut the 3mm acrylic.
 |
I then drilled two holes in the back of the shell for the battery wire and the MP3 socket to neatly come out. I put stoppers on the other sides of the wires so they could not come out any further, therefore they wouldn't look untidy and wouldn't get tangled together.
Finally, I glued all the pieces together, and my speakers were ready for action!
No comments:
Post a Comment